ASTM A1016/A1016M-17

Standard Specification for General Requirements for Ferritic Alloy Steel, Austenitic Alloy Steel, and Stainless Steel Tubes

Published by: 2017-03-15 / 2017-03-15 / 12 pages

1.1 This specification covers a group of requirements that, unless otherwise specified in an individual specification, shall apply to the ASTM product specifications noted below.

Title of Specification




Seamless Carbon-Molybdenum Alloy-Steel Boiler and
 Superheater Tubes


Seamless Ferritic and Austenitic Alloy-Steel Boiler, Superheater,
 and Heat-Exchanger Tubes


Welded Austenitic Steel Boiler, Superheater, Heat-Exchanger,
 and Condenser Tubes


Electric-Resistance-Welded Ferritic Alloy-Steel Boiler and
 Superheater Tubes


Seamless and Welded Ferritic and Martensitic Stainless Steel
 Tubing for General Service


Seamless and Welded Austenitic Stainless Steel Tubing for
 General Service


Seamless and Welded Austenitic Stainless Steel Sanitary


Seamless and Welded Carbon and Alloy-Steel Tubes for
 Low-Temperature Service


Welded Austenitic Stainless Steel Feedwater Heater Tubes


Austenitic Stainless Steel Tubing for Breeder Reactor Core


Seamless and Welded Ferritic/Austenitic Stainless Steel Tubing
 for General Service


Welded Ferritic Stainless Steel Feedwater Heater Tubes


Austenitic and Ferritic Stainless Steel Duct Tubes for Breeder
 Reactor Core Components


High-Frequency Induction Welded, Unannealed Austenitic Steel
 Condenser Tubes


(A) These designations refer to the latest issue of the respective specifications.

1.2 In the case of conflict between a requirement of a product specification and a requirement of this general requirements specification, the product specification shall prevail. In the case of conflict between a requirement of the product specification or a requirement of this general requirements specification and a more stringent requirement of the purchase order, the purchase order shall prevail.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation (SI) of the product specification is specified in the order.

Ordering and availability

This publication is available both in printed and PDF edition.

Leave a Reply

Your email address will not be published. Required fields are marked *